Output settings – Roland Sonar V-Studio VS-700 User Manual
Page 116
116
Creating a Patch
Patch Output
Patch Out Assign
Specifies how the direct sound of each patch will be output.
Value:
MFX:
Output in stereo through multi-effects. You can
also apply chorus or reverb to the sound that
passes through multi-effects.
L+R:
Output in stereo without passing through multi-
effects.
L, R:
Output in mono without passing through multi-
effects.
TONE:
Outputs according to the settings for each tone.
Tone Out Assign
Specifies how the direct sound of each tone will be output.
Value:
MFX:
Output in stereo through multi-effects. You can
also apply chorus or reverb to the sound that
passes through multi-effects.
L+R:
Output in stereo without passing through multi-
effects.
L, R:
Output in mono without passing through multi-
effects.
* If the Patch Output Assign is set to anything other than
“TONE,” these settings will be ignored.
* When the Structure Type parameter has a setting of Type
“2”–”10,” the outputs of tones 1 and 2 will be combined with
tone 2, and the outputs of tones 3 and 4 will be combined
with tone 4. For this reason, tone 1 will follow the settings of
tone 2, and tone 3 will follow the settings of tone 4 (p. 101).
* If you’ve set Tone Out Assign to “MFX,” set the MFX Output
Assign parameter to specify the output destination of the
sound that has passed through the multi-effects.
* Sounds are output to chorus and reverb in mono at all times.
* The output destination of the signal after passing through
the chorus is set with the Chorus Output Select.
Tone Out Level
Set the level of the signal that is sent to the output
destination specified by Tone Output Assign.
Value:
0–127
Tone Chorus Send
(Send Level (Output=MFX))
Specifies the level of the signal sent to the chorus for each
tone if the tone is sent through MFX.
Value:
0–127
Tone Reverb Send
(Send Level (Output=MFX))
Specifies the level of the signal sent to the reverb for each
tone if the tone is sent through MFX.
Value:
0–127
Tone Chorus Send
(Send Level (Output=non MFX))
Sets the level of the signal sent to chorus for each tone if the
tone is not sent through MFX.
Value:
0–127
Tone Reverb Send
(Send Level (Output=non MFX))
Sets the level of the signal sent to reverb for each tone if the
tone is not sent through MFX.
Value:
0–127
Output Settings
VS-700_r_e.book 116 ページ ２００８年１１月２０日 木曜日 午後２時２８分