Roland Sonar V-Studio VS-700 - Manual (Page 122)

122
Creating a Patch
Patch Mtrx Control 1–4 Source
(Patch Matrix Control 1–4)
Control 1–4 Source
(Matrix Control Source 1–4)
Sets the MIDI message used to change the tone parameter
with the Matrix Control.
Value
OFF: Matrix control will not be used.
CC01–31, 33–95: Controller numbers 1–31, 33–95
PITCH BEND: Pitch Bend
AFTERTOUCH: Aftertouch
SYS CTRL1–SYS CTRL4: MIDI messages used as common
matrix controls.
VELOCITY: Velocity (pressure you press a key
with)
KEYFOLLOW: Keyfollow (keyboard position with
C4 as 0)
TEMPO: The tempo of an external MIDI
sequencer.
LFO1: LFO 1
LFO2: LFO 2
PITCH ENV: Pitch envelope
TVF ENV: TVF envelope
TVA ENV: TVA envelope
Velocity and Keyfollow correspond to Note messages.
Although there are no MIDI messages for LFO 1 through
TVA Envelope, they can be used as Matrix Control. In this
case, you can change the tone settings in realtime by
playing patches.
• If you want to use common controllers for the entire
Fantom VS, select “SYS CTRL1”–”SYS CTRL4.” MIDI
messages used as System Control 1–4 are set with the
System Ctrl 1–4 Source parameters (p. 152).
There are parameters that determine whether or not
Pitch Bend, Controller Number 11 (Expression) and
Controller Number 64 (Hold 1) are received (p. 120).
When these settings are “ON,” and the MIDI messages
are received, then when any change is made in the
settings of the desired parameter, the Pitch Bend,
Expression, and Hold 1 settings also change
simultaneously. If you want to change the targeted
parameters only, then set these to “OFF.”
• There are parameters that let you specify whether
specific MIDI messages will be received for each channel
in a performance (p. 141). When a patch with Matrix
Control settings is assigned to a part, confirm that any
MIDI messages used for the Matrix Control will be
received. If the Fantom VS is set up such that reception
of MIDI messages is disabled, then the Matrix Control
will not function.
CTRL Destination 1–4
(Matrix Control Destination 1–4)
Matrix Control Destination selects the tone parameter that is
to be controlled when using the Matrix Control. The
following parameters can be controlled. When not
controlling parameters with the Matrix Control, set this to
“OFF.” Up to four parameters can be specified for each Matrix
Control, and controlled simultaneously.
In this manual, Parameters that can be controlled using
the Matrix Control are marked with a “ ★ .”
VS-700_r_e.book 122 ページ ２００８年１１月２０日 木曜日 午後２時２８分