Riverstone Networks WICT1-12 - Manual (Page 617)

Riverstone Networks RS Switch Router User Guide Release 8.0 30-13
WAN Configuration Monitoring PPP WAN Ports
The following table describes the commands for configuring MLP:
Compression on MLP Bundles or Links
Compression can be applied on either a bundle or link basis if MLP is enabled on PPP links. If compression is enabled
on a bundle, the packets will be compressed before processing by MLP. If compression is enabled on a link, the packets
will be compressed after the MLP processing.
In general, choose bundle compression over link compression whenever possible. Compressing packets before they
are “split” by MLP is much more efficient for both the compression algorithm and the WAN card. Link compression
is supported to provide the widest range of compatibility with other vendors’ equipment.
30.9 MONITORING PPP WAN PORTS
Once you have configured your PPP WAN interface(s), you can use the CLI to monitor status and statistics for your
WAN ports. The following table describes the monitoring commands for WAN interfaces, designed to be used in the
Enable mode:
Add PPP port(s) to an MLP bundle.
ppp add-to-mlp port
Create MLP bundle(s).
ppp create-mlp slot
Set MLP encapsulation format.
ppp set mlp-encaps-format ports
list>
[format short-format]
Set the size of frames that fragmented for
transmission on an MLP bundle.
ppp set mlp-frag-size ports
size
Set the depth of the queue used to hold MLP
packets for preserving the packet order.
ppp set mlp-orderq-depth ports
qdepth
Set the depth of the queue used to hold packet
fragments for reassembly.
ppp set mlp-fragq-depth ports
qdepth
Display a particular PPP service profile.
ppp show service
Display all available PPP service profiles.
ppp show service all
Display bridge NCP statistics for specified PPP WAN
port. ppp show stats port bridge-ncp
Display IP NCP statistics for specified PPP WAN port. ppp show stats ports ip-ncp
Display link-status statistics for a specified PPP WAN
port.
ppp show stats ports
link-status
Displays information for PPP ports that are added to
MLP bundles. ppp show mlp | all-ports