Roland VR-760 - Manual (Page 77)

77
Detailed Settings for Each Function (EDIT)
EDIT
Bulk Dump Temp
Transmit the contents of the selected Registration.
1. Hold down the [EDIT] button, and press the
REGISTRATION [7] (UTILITY) button.
The Edit’s “UTILITY” screen is displayed.
2. Press CURSOR [ ] button to display the
following screen.
fig.06-04(BulkDumpTemp)
Pressing the [EXIT] button, return to the basic screen.
3. Start recording on your sequencer.
4. Press the [ENTER] button to begin saving the
settings.
While the settings are being saved, sending message is
displayed.
When the save has been completed, a message
indicating that it is completed appears in the
display
, and return to the basic screen.
5. Stop recording on your sequencer.
Bulk Dump All
This send all settings.
1. Hold down the [EDIT] button, and press the
REGISTRATION [7] (UTILITY) button.
The Edit’s “UTILITY” screen is displayed.
2. Press CURSOR [ ] button to display the
following screen.
fig.06-05(BulkDumpAll)
Pressing the [EXIT] button, return to the basic screen.
3. Start recording on your sequencer.
4. Press the [ENTER] button.
A screen like the one shown below appears, and saving
the settings is beginning.
fig.06-06(Sending)
After a short while, when transmission is finished, a
message indicating that it is completed appears and
the basic screen returns to the display.
5. Stop recording on your sequencer.
6. If you press [EXIT] button while transmission is
still in progress, the following message appears,
and the basic screen returns to the display.
fig.06-07(Aborted!)