Roland VR-760 - Manual (Page 18)

18
Before You Begin Playing
■ Connecting Pedals
Connect the optional pedal (DP-8, etc) to one of the Pedal jacks.
When connected to the Damper jack, the pedal can be used as a damper
pedal.
Connecting the pedal to the CONTROL jack allows you to assign a variety
of functions to the pedal (p. 66).
fig.01-03(Connecting Pedals)
Installing the Music Stand
fig.01-01
1.
Using the supplied screws, fasten the music stand to the
back of the VR-760 as illustrated.
Be sure to use the supplied screws for attaching the music stand.
Turn the screws clockwise to tighten them.
When attaching the music stand, support it firmly with one hand to make
sure that you do not drop it. Be careful, so you do not get your fingers
pinched.
2.
To remove the music stand, support it with one hand while
loosening the screws.
NOTE
Use only the specified
expression pedal (EV-7;
sold separately). By
connecting any other
expression pedal, you risk
causing malfunction and/
or damage to the unit.
NOTE
With the factory settings,
the damper effect is not
applied to the organ part
(p. 65).
Roland
Pedal switch
(DP-2, DP-6 etc.)
Expression pedal (EV-7)
or Pedal switch Half-damper pedal (DP-8)
or Pedal switch
NOTE
With the factory settings,
the expression effect is not
applied to the piano part
(p. 65).
NOTE
Do not apply excessive
force to the installed music
stand.