Roland VR-760 - Manual (Page 19)

19
Before You Begin Playing
Before You Begin Playing
Turning the Power On and Off
NOTE
Once the connections have been completed, turn on power to your various
devices in the order specified. By turning on devices in the wrong order, you
risk causing malfunction and/or damage to speakers and other devices.
■ Turning On the Power
1.
Before you switch on the power, turn the volume down all
the way by rotating the [MASTER VOLUME knob.
Also completely turn down the volume of any connected audio device and
other equipment.
fig.01-03(Volume)
2.
Press the upper portion of the [POWER] switch on the back
of the VR-760 to turn on the power.
The unit is powered up, and the display’s backlighting comes on.
fig.01-04(switch)
3.
Turn on the power to connected external devices.
4.
Adjust the volume of the connected external device.
5.
Adjust the VR-760’s volume to obtain the proper volume
level.
■ Turning Off the Power
1.
Before you switch on the power, turn the volume down all
the way by rotating the [MASTER VOLUME] knob.
Also completely turn down the volume of any connected audio device and
other equipment.
2.
Turn off the power to connected external devices.
3.
Press the lower portion of the [POWER] switch on the back
of the VR-760.
The power is switched off.
NOTE
To prevent incorrect
functioning of the Pitch
Bend Lever (p. 14), refrain
from touching the lever
while the power to the VR-
760 is turned on.
NOTE
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.