Roland AT15 - Manual (Page 70)

70
Record and Playback Your Performance
Formatting Disks
Floppy disks must first be “formatted” (initialized) before they can be used
by the AT-15 to store data. “Formatting” is the process of erasing any data
which may have been on the disk and making the format of the floppy disk
match the format of the device. The AT-15 cannot use a floppy disk that has
a format differing from its own format.
fig.08-11
1.
Make sure that the write protect tab of the floppy disk is in
the “Write” (permit) position.
fig.08-12
2.
With the label of the floppy disk facing upward, insert it
into the disk drive until it clicks into position.
3.
Press the [Utility] button.
NOTE
Formatting a disk will erase
any data that may have
been stored on it. Carefully
check any previously used
disk to be sure it doesn’t
contain any valuable data.
4, 6
5, 7, 8
3
Protect
(prevents writing to disk)
Write
(can write new data onto disk)
Write Protect Tab
AT-15_e.book 70 ページ ２００５年１月２１日 金曜日 午後８時１４分