93 detailed settings for each function ([edit]), Bulk dump setup, Restoring saved settings to the rd-700 – Roland RD-700 User Manual
Page 93
93
Detailed Settings for Each Function ([EDIT])
Edit Mode
Bulk Dump SETUP
6
Press CURSOR [
].
A screen like the one shown below appears.
7.
Press CURSOR [
] / [
] and [INC/YES]/[DEC/
NO] to set the transmitted SETUPs.
8.
Press CURSOR [
].
A screen like the one shown below appears.
fig.Editmenu2.eps_150
9.
Put the external sequencer in record mode.
10.
Press [INC/YES] to transmit the settings.
To cancel the Bulk Dump, press [DEC/NO].
A screen like the one shown below appears.
fig.Editmenu2.eps_150
11.
After the transmitting is finished, the display will
indicate “COMPLETED.”
You are returned to the Edit screen.
12.
Stop the external sequencer.
Restoring saved settings to the RD-700
When returning settings saved to an external sequencer back
to the RD-700, an Exclusive message is transmitted from the
external sequencer, then the data is received by the RD-700.
NOTE
Be aware that when you restore SETUPs data to the RD-700,
the data in the RD-700 will be overwritten and lost.
1.
Use a MIDI cable to connect the MIDI OUT connector of
the external sequencer to the MIDI IN connector of the
RD-700.
2.
Set the device ID number to the same setting as when
you performed the bulk dump.
Setting the Device ID Number
➔
3.
Make sure that [EDIT] indicator is extinguished.
If the [EDIT] indicator is lit, press [EDIT] to turn the
indicator light off and put the RD-700 in normal
performance mode.
4.
Transmit (play back) the data from the external
sequencer.
5.
After the transmitting is finished, the display will
indicate “COMPLETED.”
NOTE
After playback of the Bulk Dump SETUP data, the RD-700
writes the data to the internal memory. Be sure never to turn
off the power while this data is being written (while “Now,
writing Bulk Dump Data. Keep on POWER!” is showing).
For details on transmitting exclusive data, refer to the
owner’s manual for your sequencer.
NOTE
Play back the external sequencer at the same tempo you used
when performing the bulk dump. If you use a faster tempo,
the data may not be restored correctly.
NOTE
Data cannot be received if the Device ID of the receiving
device differs from the Device ID used when Bulk Dump was
carried out.
NOTE
Exclusive messages cannot be received when set to GM
Mode (p. 98). Carry out the operation after first exiting GM
Mode.
Parameter
Value
From
Setup number for the first Setup to
be transmitted.
To
Setup number for the last Setup to be
transmitted.
Send System
Determines whether the system set-
tings are to be transmitted (YES), or
not (NO).
RD-700_e.book 93 ページ ２００３年１０月２３日 木曜日 午後４時５９分