Roland RD-700 - Manual (Page 27)

27
Getting Ready
Getting Ready
fig.utility1.eps_150
4
Press CURSOR [ ] to select “Factory Reset All.”
5
Press CURSOR [ ].
A screen like the one shown below appears.
fig.utility1.eps_150
To cancel the Factory Reset, press [DEC/NO].
6
Press [INC/YES].
The confirmation message appears.
fig.LCD_150
To cancel the Factory Reset, press [DEC/NO].
7
Press [INC/YES] once again to start the Factory Reset
operation.
During the execution, “Now, Executing” appears in the display.
After the Factory Reset operation is finished, the display will indicate
“COMPLETED” and the Tone screen will appear.
After performing a Factory
Reset, you may need to re-
adjust the display contrast.
When this occur, adjust
depth of the display (p. 28).
You can also restore only part of the setting to their factory status. Refer to
“Restoring the settings to the factory condition (Factory Reset)”
(p. 94).
RD-700_e.book 27 ページ ２００３年１０月２３日 木曜日 午後４時５９分