Raritan Computer Paragon switch - Manual (Page 68)

60 P ARAGON A DMINISTRATOR ’ S I NSTALLATION AND O PERATION G UIDE
Note: Banking exemplifies Raritan’s dedication to future development. Banking
Technology, a potentially improved KVM configuration design that conceivably
banks or links Matrix Switching Units directly to each other, is currently non-
functional. As a result, all Bank IDs should be set to 1.
6. Re-Configure: Paragon will automatically configure the system as computers or devices are
added or removed. However, the system administrator can use this function to scan and re-
configure the system manually. When complete, it will return to normal display.
R
E
-C
ONFIGURE
S
EARCHING
N
OW
…
Figure 52 Auto Configure
7. Reset UMT8 Switch (Paragon Unit Switch): Enables restart of Paragon switch unit as if unit’s
power had been physically turned off and back on again. However, the Paragon switch will not
perform start-up test unless ENT button is held down during restart.
With Paragon switch firmware 2B1 and User Station (UST1) firmware 2K10 or higher, either a
power reset or a factory “function” reset can be performed from the front panel of the Paragon
switch using shortcut button combinations.
Power Reset:
Hold the [] and [] buttons on the front panel of the Paragon switch simultaneously for
approximately three seconds. When the front panel stops scrolling, release the buttons.
Factory “Function” Reset:
Hold the [] and [] buttons on the front panel of the Paragon switch simultaneously while
pressing the [FUNC] button. When the front panel stops scrolling, release the [] and [] buttons,
wait an additional three seconds, then release the [FUNC] button.