Nortel Networks 1000BASE-SX - Manual (Page 36)

36 10 Gigabit small form factor pluggable transceivers
Procedure job aid: XFP models
XFPs are hot-swappable input/output enhancement components designed
for use with Nortel products to allow 10 Gigabit Ethernet ports to link with
other 10 Gigabit Ethernet ports. Digital diagnostic monitoring (DDM) allows
real-time access to device operating parameters. All XFPs come with DDM
capability.
All Nortel XFPs use LC connectors to provide precision keying, low interface
losses, and space savings.
The following table lists and describes the Nortel XFP models. For
specifications for these XFPs, see
"XFP specifications" (page 73) .
ATTENTION
You can configure the XFP to operate in either LAN or WAN mode, depending
on the module (8683XLR is a LAN-only module, and 8683XZR is a LAN/ WAN
module). Model numbers ending in R denote a LAN interface; model numbers
ending in W denote a WAN interface.
CAUTION
Nortel recommends that you install only one 10GBASE-ZR/ZW
XFP per module due to cooling limitations on the 8683XLR and
8683XZR modules. Nortel further recommends the installation of
the XFP only in port 1. You can install a 10GBASE-SR, -LR/LW, or
-ER/EW in one or both of the remaining ports.
Table 6
XFP models
Model number Product number Description
10GBASE-SR AA1403005-E5 850 nanometers (nm). The range is up to:
• 22 m using 62.5 micrometer (
µ
m), 160
megaHertz times km (MHz-km) MMF
• 33 m using 62.5
µ
m, 200 MHz-km MMF
• 66 m using 62.5
µ
m, 500 MHz-km MMF
• 82 m using 50
µ
m, 500 MHz-km MMF
• 300 m using 50
µ
m, 2000 MHz-km MMF
10GBASE-LR/LW AA1403001-E5 1310 nm SMF. The range is up to 10 km.
10GBASE-ER/EW AA1403003-E5 1550 nm SMF. The range is up to 40 km.
10GBASE-ZR/ZW AA1403006-E5 1550 nm SMF. The range is up to 80 km.
Nortel Metro Ethernet Routing Switch 8600
Installation — SFP, XFP, GBIC, and OADM Hardware Components
NN46220-301 01.01 Standard
5.0 1 May 2008
Copyright © 2008, Nortel Networks
.