Nortel Networks 1000BASE-SX - Manual (Page 26)

26 Small form factor pluggable transceivers
Procedure steps
CAUTION
SFPs are keyed to prevent incorrect insertion. If the SFP resists
pressure, do not force it; turn it over, and reinsert it.
Step Action
1 Remove the SFP from its protective packaging.
2 Grasp the SFP between your thumb and forefinger.
3 As shown in the following figure, insert the device into the slot on
the module.
Apply a light pressure to the device until it clicks and locks into
position.
Figure 1
Installing an SFP
4 Remove the dust cover from the optical bore and insert the fiber
optic connector.
—End—
Nortel Metro Ethernet Routing Switch 8600
Installation — SFP, XFP, GBIC, and OADM Hardware Components
NN46220-301 01.01 Standard
5.0 1 May 2008
Copyright © 2008, Nortel Networks
.