NEC Express 320Lc-R - Manual (Page 136)

Troubleshooting 6-17
a-5. The message of update completion will be displayed.
"[Update of the driver Completion]
Press any key and terminate."
b) When N8803-031F (Fibre Channel Controller) is connected
b-1. Start up [Device Manager] by selecting [Start] - [All Programs] - [Administrative
Tools] - [Computer Management].
Check to see [Qlogic QLA23xx PCI Fibre Channel Adapter] appears under [SCSI
and RAID Controllers].
You do not need to perform the steps b-2 and later if the number of [Qlogic
QLA23xx PCI Fibre Channel Adapter]s shown is identical to number of actually
implemented [Qlogic QLA23xx PCI Fibre Channel Adapter]s. If not, go to b-2.
b-2. Right-click the [Unknown Device] – [Fibre Channel Controller] on the [Device
Manager], and select [Update Driver].
b-3. Select [Install from a list of specific location (Advanced)], and then click [Next].
b-4. Select [Don’t search. I will choose the driver to install.], and then click [Next].
b-5. Select [SCSI and RAID Controllers], and then click [Next].
b-6. Do not select a driver on the model list. Click [Have Disk…].
b-7. Insert NEC EXPRESSBUILDER into the CD-ROM drive and click [Browse].
Specify the “CD-ROM drive:\WINNT\DRIVERS\QL2300” folder in the “Copy
manufacture’s files from:” column, and then click [OK].
b-8. Select [Qlogic QLA23xx PCI Fibre Channel Adapter] on the model list and click
[Next].
b-9. A warning message tells that you are about to update a driver. Click [Yes] to
continue. The driver will be installed. During the processing, the mouse cursor
may not be moved for 10 to 20 seconds. Please wait.
b-10. Click [Finish].
b-11. Check to see that the number of [Qlogic QLA23xx PCI Fibre Channel Adapter]s
shown is identical to number of actually implemented [Qlogic QLA23xx PCI
Fibre Channel Adapter]s. If not, repeat the steps 2 to 10.
c) When N8104-84 (1000BASE-SX Adapter) is connected
c-1. Execute [Command Prompt].
c-2. Run the following command from Command Prompt and move to CD-ROM
drive.
C:\> CD-ROM drive:
c-3. Run the following command from Command Prompt and move to the folder with
the batch file.
CD-ROM drive:\> cd \WINNT\DOTNET\EN
c-4. Run the following command from Command Prompt for updating the driver.
CD-ROM drive:\WINNT\DOTNET\EN> N810484.BAT
c-5. The message of update completion will be displayed.
"[Update of the driver Completion]
Press any key and terminate."
d) When N8104-103 (1000BASE-T Adapter) is connected
d-1. Execute [Command Prompt].
d-2. Run the following command from Command Prompt and move to CD-ROM
drive.
C:\> CD-ROM drive: