Nortel Networks SRG50 - Manual (Page 61)

Chapter 5 IP telephones setup and configuration 61
SRG50 Configuration Guide
The disadvantage of the second option is that the installer must configure the target
DN in two places: on the Active Sets panel and on the SRG-specific panels (the
SRG-specific panels must be completed). The SRG looks at the SRG-specific panels
first. It goes to the Active Sets panel only if the VOIP Trunk Access Code has not
been configured.
Configuration settings for redirected phones
The Telephony Device Installation Guide and the Networking Configuration Guide provide
detailed instructions for configuring IP telephones. For IP telephones that are redirected to the
main office call server, incorporate the settings shown in the table
Configuration settings for
redirected IP telephones on page 61.
For more information, see CS 1000 considerations on page 33.
Test Local Mode
An IP telephone operating in normal mode can be forced to redirect to the SRG. This allows the
telephone user, and system administrator, to test local mode operation without taking down the
VoIP trunk to the main office.
To activate Test Local Mode
1 From the telephone dialpad, press the Services key .
2 Press the Test Local Mode button.
The telephone is now in Test Local Mode.
Table 14 Configuration settings for redirected IP telephones
Parameter CS 1000
S1 IP SRG IP address
S1 Port 7300
S1 Action 1
S1 Retry Count 1
S2 IP SRG IP address
S2 Port 7300
S2 Action 1
S2 Retry Count 1