Nortel Networks SRG50 - Manual (Page 45)

Chapter 4 CS 1000 considerations 45
SRG50 Configuration Guide
H323 ID SRG* (default)
*This setting must be changed.
see the Networking Configuration
Guide (NN40020-603) for naming
conventions.
Gatekeeper setting that identifies the SRG.
This value must match the value in the Alias
names field of the Local IP gateway:
Configuration > Resources > Telephony
Resources > Modules panel > Module type
column: select IP Trunks > Details for Module:
Internal details panel > Local Gateway tab >
Gatekeeper Support subpanel > Alias names
field (see
VoIP trunking configuration on page 72).
The SRG acts as a SIP endpoint and obtains the
Main Office TPS IP address from the NCS using
the H323 ID.
Configure this field as the same SIP endpoint name
as you configure for the NRS endpoint name. This
is a generic field used for both SIP and H.323
virtual trunk configurations.
Numbering Plan ID Unknown
ISDN/Telephony (E.164)
Private
Telephony (E.163)
Telex (F.69)
Data (X.121)
National Standard
Default: Private
The type of numbering plan at the main office.
Type of Number Unknown
International Number
National Number
Special Number
Subscriber Number
ESN LOC (UDP)
ESN CDP
ESN Special Number
Default: ESN CDP (for CDP dialing
plans) (BUID = DN)
UDP dialing plans: select ESN
LOC (UDP) (BUID = LOC+DN)
The main office dialing plan.
Ensure that the SRG private dialing plan is
configured to match the selected value.
Table 8 S1000 Main Office Settings (Sheet 2 of 3)
Field Values Description