Task flows for individual servers, Linux base and applications installation and – Nortel Networks NN43001-315 User Manual

Page 13

Linux base and applications
installation and upgrade task flow

Linux Platform Base and Applications Installation and Commissioning
(NN43001-315) () provides installation and upgrade information for the
Linux base and applications. You must follow the proper sequence of
events to correctly install or upgrade the Linux base and applications. Use
the task flow information in this chapter to determine the proper steps for
the installation or upgrade of the Linux base and applications.

The task flows for Linux base and applications installation and upgrades
are broken into two sections:

•

Task flows to install or upgrade individual servers, as shown in

“Task

flows for individual servers” (page 13)

•

Task flows to install or upgrade commonly used combinations of
servers, as shown in

“Task flows for common combinations of servers”

(page 21)

There is also a section for upgrading the ECM. See

“ECM Upgrade

Procedures” (page 28)

Task flows for individual servers

This section provides high-level task flows for the installation and upgrade
of the Linux base and applications on commercial off-the-shelf (COTS)
servers. Refer to the chapters

“Install Nortel Linux base ” (page 35)

and

“Installation and configuration of applications on Linux base” (page 69)

for

specific installation instructions. Refer to the chapter

“Upgrade Nortel Linux

base ” (page 53)

for specific upgrade instructions.

For more information refer to the following NTPs, which are referenced in
the task flow diagrams:

•

Linux Platform Base and Applications Installation and Commissioning
(NN43001-315) ()

•