Nortel Networks NN43001-315 User Manual
Page 117
Disaster recovery
117
•
yyyy - year
•
mm - month
•
dd - day
•
hh - hour
•
MM - minutes
•
ss - seconds
Nortel Linux base uses the CLI command
sysbackup
to backup system
data to external storage. You can choose to back up the data to a USB
device or to an SFTP server. For more information about SFTP data back
up, see
“Network configuration for Secure File Transfer Protocol (SFTP)
.
Note:
Only one USB storage device should be attached during
backup/restore command execution.
The backup operation has two modes; interactive and noninteractive.
Interactive backup is performed by using the CLI command
sysbackup
–b
. Interactive backup performs a single backup operation and is intended
to backup data before and after critical changes to the system. Interactive
backup can be used as an irregular or on-demand backup. Noninteractive
backup is performed by using the CLI command
sysbackup –c
.
Noninteractive backup performs a regular or scheduled backup. You
can configure a Noninteractive backup as shown in
and
Figure 109 "Backup Scheduler 2" (page 118)
Note:
The minutes parameter in the backup scheduler does not
support asterisk as a valid parameter.
Figure 108
Backup Scheduler 1
Nortel Communication Server 1000
Linux Platform Base and Applications Installation and Commissioning
NN43001-315
02.09
29 October 2008
Copyright © 2007–2008 Nortel Networks
.