Philips KX-PNBC8 User Manual
Page 22
22
20. Repeat steps 18 and 19 to finish entering all the 3-digit values of the
Gateway Address.
A message to confirm the Gateway Address is displayed.
21. Press the ENTER button.
The printer restarts the system automatically, and “Initializing” is
displayed.
22. After approximately 3 minutes, you may check your settings.
(1)On your computer, click Start, select Programs, then click
- MS-DOS Prompt.(for Windows 95/Windows 98)
- Command Prompt.(for Windows NT 4.0)
(2)From the DOS prompt type “ping” followed by a space then the
printer’s IP Address, then press the ENTER key.
For example, ping 179.40.0.5.
If the following notation is displayed, they are set correctly.
Pinging 179.40.0.5 with 32 bytes of data:
Reply from 179.40.0.5: bytes=xx time Reply from 179.40.0.5: bytes=xx time ................................................ ................................................ If the ping command returns a “ Request timed out ” message or “ Reply from xxx.xxx.xxx.xxx: Destination host unreachable ” message or other error messages you should recheck your settings. If they are not set correctly, you should Chapter 2 on . xxx.xxx.xxx.xxx OK? Initializing
go back to
Yes