Philips KX-PNBC8 - Manual (Page 19)

19
When Setting by Direct Entering in Step 1
If the administrator manages the IP address, contact your network administrator to
confirm the values of the IP address. If not, set the unique value that is not used for
any other device on the network by referring to
When Setting by Direct Entering on
page 17 .
The value can be set using the printer LCD panel.
1. Press the MENU/EXIT button.
The printer enters the Menu mode and “Test Page” is displayed.
2. Press the button twice (or press the button 5 times).
“Network Protocol setup” is displayed.
3. Press the ENTER button.
“DHCP” is displayed.
4. Press the ENTER button.
The printer enters the DHCP Setting mode.
5. Press the button (or the button).
“Disable” is displayed.
6. Press the ENTER button.
“Ethernet IP Address” is displayed.
Menu Mode
Test Page
Menu Mode
Network Protocol setup
Network Protocol setup
DHCP
DHCP
Enable*
DHCP
Disable
Network Protocol setup
Ethernet IP Address