Appendix a jumper settings, Appendix a, Jumper settings – Philips KX-PNBC8 User Manual
Page 136
136
Appendix A
Jumper Settings
The Network Card will normally automatically configure the network configuration
without the need to access internal jumpers. However, there are certain jumpers on
the board that you may have to access under certain circumstances. If you need to
change the jumpers, follow the steps in this section.
HANDLING PRECAUTIONS
FOR
STATIC SENSITIVE DEVICES
The Network Card is normally contained within the printer which acts to protect sensitive
components from damage due to electrostatic discharge (ESD) during normal operation.
When performing installation procedures, however, take proper static control precautions
to prevent damage to equipment.
Make sure you do not have the printer plugged into a wall outlet. If it is, unplug the
power cord Before you open the unit. Remove the Network Card according to the
printer instructions.
- SWA3301S/17 (1 page)
- Duplex SDJ6130W (2 pages)
- Swarovski SW60/27 (2 pages)
- PSC705 (34 pages)
- SNA6500 (47 pages)
- PSC702 (2 pages)
- PSC70217 (2 pages)
- SWV2591W (2 pages)
- 3LR12PBXC/10 (2 pages)
- PCA102CD (47 pages)
- S26.7912-006 (1 page)
- VOIP080IB (2 pages)
- PSC 604 (10 pages)
- HAPPY LAURA FM02SW00/00 (2 pages)
- WAR1900 (2 pages)
- SWV3558 (2 pages)
- FM01SW60 (72 pages)
- SWV3458W/17 (2 pages)
- SPE3071CC (2 pages)
- SWV4157W (2 pages)
- SPD5240 (51 pages)
- PH0900L (29 pages)
- Swarovski FM01SW40/00 (2 pages)
- FM02FD02B/00USB (2 pages)
- CGA7740N (26 pages)
- SNA6640 (42 pages)
- SJM2121 (2 pages)
- US2-P72069 (2 pages)
- FM02SW00 (104 pages)
- Mercury 1314L2S (2 pages)
- PHOTOFRAME 7FF1CWO (51 pages)
- SDJ6070W (2 pages)
- SJA9480 (2 pages)
- SWV3011W (2 pages)
- SCU5120NB (2 pages)
- TDA6800 (10 pages)
- SHOWVIEW VR400 (2 pages)
- SWV3459W/17 (2 pages)
- SWV3458W/27 (2 pages)
- Swarovski FM01SW21/00 (2 pages)
- TDA8767 (20 pages)
- SAA2051W (2 pages)
- SPE2010CC (2 pages)
- SCU3050NB (2 pages)
- SDJ6120W (2 pages)