Paradyne FrameSaver SLV 9664 - Manual (Page 68)

Configuration
3-40 9664-A2-GB20-00 March 2000
Configuring Telnet and/or FTP Session Support
Telnet and FTP options control whether a Telnet or FTP (File Transport Protocol)
session is allowed through an interconnected IP network and the access security
applicable to the session. Two Telnet sessions can be active at a time
(see Table 3-12).
Main Menu
→
Configuration
→
Management and Communication
→
Telnet and FTP Session
When a TS Management Link has been set up and activated, the following
options have no effect upon the PVC:
H
Telnet Login Required
H Session Access Level
H
FTP Login Required
Table 3-12. Telnet and FTP Session Options (1 of 3)
Telnet Session
Possible Settings: Enable, Disable
Default Setting: Enable
Specifies whether the FrameSaver unit will respond to a session request from a Telnet
client on an interconnected IP network.
Enable – Allows Telnet sessions between the FrameSaver unit and Telnet client.
Disable – Does not allow Telnet sessions.
Telnet Login Required
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies whether a user ID and password (referred to as the login) are required to
access the menu-driven user interface via a Telnet session. If required, the login used is
the same login used for an menu-driven user interface session. This option does not
affect the TS Management Link.
Enable – Requires a login to access a Telnet session.
Disable – Does not require a login.