Tests available, Test timeout feature – Paradyne FrameSaver SLV 9664 User Manual

Page 142

Troubleshooting

6-12

9664-A2-GB20-00

March 2000

Tests Available

The following tests are available to a FrameSaver SLV 9664.

Test Menu Example

ООООООООООООООООООООООООО

main/test

9664

Device Name: Node A

5/26/1999 23:32

TEST

Network PVC Tests

Data Port PVC Tests

Data Port Physical Tests

IP Ping

Lamp Test

Abort All Tests

––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

Ctrl-a to access these functions, ESC for previous menu

MainMenu

Exit

PVC Tests menu selections are suppressed when no PVCs have been configured
on the interface. Check that both ends of the cables are properly seated and
secured.

Tests can be commanded from the OpenLane 5.

x management solution using its

Diagnostic Troubleshooting graphical interface, as well as from the menu-driven
user interface.

Test Timeout Feature

A Test Timeout feature is available to automatically terminate a test (as opposed
to manually terminating a test) after it has been running a specified period of
time.

It is recommended that this feature be used when the

FrameSaver unit is

remotely managed through an inband data stream (PVC). If a test is accidently
commanded to execute on the interface providing management access, control is
regained when the specified time period expires, automatically terminating the
test.

To use this feature, enable the Test Timeout configuration option, and set a
duration for the test to run in the Test Duration (min) configuration option (see

Configuring General System Options

in Chapter 3,

Configuration).