Starting and stopping a test, Aborting all tests – Paradyne FrameSaver SLV 9664 User Manual
Page 143
Troubleshooting
6-13
9664-A2-GB20-00
March 2000
Starting and Stopping a Test
Use this procedure to start, monitor, or abort specific tests. To abort all active
tests on all interfaces, see
When the status of a test is . . .
The only command available is . . .
Inactive
Start
Active
Stop
Start or stop an individual test using the same procedure.
"
Procedure
To start and stop a test:
1. Select the Test menu.
Main Menu
→
Test
2. Highlight the Start command for the test you want to start and press Enter.
Stop
now appears and is highlighted, and the status of the test changes to
Active
.
3. Press Enter to stop the test.
Start
reappears and the status of the test changes back to
Inactive
.
4. View the length of time that the test has been running in the Result column.
Aborting All Tests
Use the Abort All Tests selection from the Test menu to abort all tests running on
all interfaces, with exception to DTE-initiated loopbacks. To abort individual tests
that are active, see
"
Procedure
To abort all tests on all interfaces:
1. Select the Test menu.
Main Menu
→
Test
2. Select Abort All Tests and press Enter.
Command Complete
appears when all tests on all interfaces have been
stopped.
NOTE:
Abort All Tests does not interrupt DTE-initiated loopbacks.