Paradyne FrameSaver SLV 9664 - Manual (Page 191)

SNMP MIBs and Traps, and RMON Alarm Defaults
B-5 9664-A2-GB20-00 March 2000
NetScout Indexes to the Interface Table (ifTable)
For remote monitoring at sites where FrameSaver units are operating with
NetScout Probes, use the following ifName, ifDescr, and ifIndex.
Table B-2. NetScout Interface Objects Information
ifName Description ifDescr (ifEntry 2) ifIndex
Frame Relay Logical Layer
Frame Relay 1
Network Network ISDN S/T For the user side:
RMON (IN/OUT); Network
ISDN S/T of FR DTE; Child
Card: LL S/T FR NIM;
S/W Release:
MM.mm.bb;
Hardware Version: hhhh-hhh
1
For the network side:
RMON (IN/OUT); Network
ISDN S/T of FR SERVICE;
Child Card: LL S/T FR NIM;
S/W Release:
MM.mm.bb;
Hardware Version: hhhh-hhh
RMON Logical Layer
RMON Frame
Relay Logical
Interfaces These values are
calculated.
H For the DTE:
IN – RMON (IN); [ ifName of the
interface]
17– 48
H For the DTE:
(ifIndex –1) * 2 +17
H For the DCE: DTE
calculated value +1
OUT – RMON (OUT);
[
ifName of the interface]
RMON Virtual
Interfaces These values are
calculated based on
the probe’s internal
circuit index: circuit
index +65. VIRTUAL PVC
[
interface number ]
[ DLCI number ] ALL
65 – 512
RMON Virtual
Logical
Interfaces These values are
calculated.
H For the DTE:
(virtual interface
ifIndex – 65) * 2
IN – VIRTUAL PVC
[
interface number ]
[ DLCI number ] DTE
513 –1023
ifIndex – 65) * 2
+513
H For the DCE:
DTE calculated
value +1
OUT – VIRTUAL PVC
[
interface number ]
[ DLCI number ] DCE