Parker Products ViX250AE - Manual (Page 89)

VIX AE SERVO DRIVE USER GUIDE 82
Use this screen to
configure the brake
input to match the
output generating
the brake signal.
The screen also
allows selection of
the type of
simulated encoder
output or input
required.
Click ‘Next>’.
•
High logic level 24V source (IC = 256) [upper box ticked lower blank] (default)
•
High logic level 24V sink (IC = 257) [upper and lower boxes ticked]
•
Low logic level 5V source (IC = 0) [no boxes ticked]
Note: Upper box blank and lower box ticked is a non-valid configuration, see WARNING
below.
WARNING – risk of equipment damage
Do not attempt to drive the brake input with a low logic level (5V) sink output.
Internally, the drive pull-up voltage is 24V.