beautypg.com

Planet Technology WGS3-2620 User Manual

Page 69

background image

WGS3 Layer 3 Switch User’s Manual

- 61 -

4.5.1 Setting the System Operation Mode), the IP Menu will be displayed. Use this menu to configure the

IP subnets for each VLAN on your switch, the unicast and multicast routing protocols, static ARP entries,

static IP routes, and the default IP Route.

Parameter Description

Subnet Configuration

Specifies the IP interface for VLANs configured on this switch, including the

subnet address and routing

Protocols

Protocol Configuration

Configures ARP timeout, enables Proxy ARP, sets the preferred servers for

BOOTP/DHCP Relay, as well as enabling/configuring unicast and multicast

protocols globally for this switch.

Static ARP Configuration Used to map an IP address to a specific physical MAC address

Static Route

Used to configure static routes to other IP networks, subnetworks, or hosts.

Default Route

Defines the router to which this switch will forward all traffic for unknown

networks.