Planet Technology WGS3-2620 User Manual
Page 122
WGS3 Layer 3 Switch User’s Manual
- 114 -
Parameter Description
Destination
Network
A destination network, subnet or host.
Destination Mask The subnet mask that specifies the bits to match. A routing entry will be used for a
packet if the bits in the address set by the destination mask match the Destination
Network.
VLAN
The VLAN within which the gateway or destination address resides.
Next Hop
The IP address of the router at the next hop.
Type
The IP route type for the destination network. This switch supports the following types:
Direct - A directly connected subnetwork.
Indirect - A remote IP subnetwork or host address.
Myself - A switch IP address on a specific IP subnetwork.
Bcast - A subnetwork broadcast address.
Mcast - An IP multicast address.
Invalid - An illegal IP address to be filtered.
Protocol
The route was learned in one of the following ways:
Local - Manually configured
Mgmt - Set via SNMP
ICMP - Obtained via ICMP redirect.
RIP - Learned via RIP protocol.
OSPF – Learned via OSPF protocol.
Other - Learned by some other method.
NOTE: Use the
specific page, set the page number in the Page field and then press RIP> to clear any routing entries learned through RIP.