4 module hardware description, 1 panel description, 2 wgsw-c1gt led definition – Planet Technology WGS3-2620 User Manual
Page 15
WGS3 Layer 3 Switch User’s Manual
- 7 -
Console
Buzzer Button
Power
Port
Function
Power
This is where you will connect the AC power cord. 100~240VAC is allowed.
Console
This is where you will connect to the RS-232 serial port on your PC for
configuring the management function, discussed in Chapter 3.
NOTE: To depress the Buzzer button will change the reaction of the buzzer. If the button is set to on,
the buzzer will ring as the system is under the status of overheat. Set to off, the buzzer will not
work even if the system overheats.
2.2.4 Module Hardware Description
WGS3-404 provides 4 slots for optional Gigabit copper and fiber module. The following picture show
that front panel of gigabit expansion module.
2.2.4.1 Panel Description
WGSW-C1GT Module Status LEDs
WGSW-C1SX Module Status LEDs
2.2.4.2 WGSW-C1GT LED Definition
LED
Color
Function
1000 Green Lights to indicate that the Switch is sending or receiving data at 1000
Mbps.
100 Green Lights to indicate that the Switch is sending or receiving data at 100
Mbps.
10 Yellow
Lights to indicate that the Switch is sending or receiving data at 10
Mbps.
FDX/COL Yellow
Lights green to indicate that the port is operating in full-duplex mode.
Blinks orange periodically to indicate that the connection is experiencing
collisions.
Act Green Lights to indicate that the connection is acting.