beautypg.com

3 configuring port trunks – Planet Technology WGS3-2620 User Manual

Page 50

background image

WGS3 Layer 3 Switch User’s Manual

- 42 -

4.5.2.3 Configuring Port Trunks

Ports can be combined into an aggregate link to increase the bandwidth of a network connection or

ensure fault recovery. You can configure trunks between any two switches. The ports on this switch can

be grouped into a trunk consisting of two, four or eight ports, creating an aggregate bandwidth to 400,

800, 1600, 4000 or 8000 Mbps when operating at full duplex. Besides balancing the load across each

port in the trunk, the additional ports provide redundancy by taking over the load if another port in the

trunk should fail. However, before making any physical connections between devices, use the Port

Trunking Configuration menu to specify the trunk on the devices at both ends. When using a port trunk,

remember that::

• The ports that can be assigned to the same trunk on WGS3-2620 are listed below:

Two ports as a trunk
<<13, 01>> <<14, 02>> <<15, 03>> <<16, 04>>
<<17, 05>> <<18, 06>> <<19, 07>> <<20, 08>>
<<21, 09>> <<22, 10>> <<23, 11>> <<24, 12>>
Four ports as a trunk
<<13, 01, 14, 02>> <<15, 03, 16, 04>>
<<17, 05, 18, 06>> <<19, 07, 20, 08>>
<<21, 09, 22, 10>> <<23, 11, 24, 12>>
Eight ports as a trunk
<<13, 01, 14, 02, 15, 03, 16, 04>>
<<17, 05, 18, 06, 19, 07, 20, 08>>
<<21, 09, 22, 10, 23, 11, 24, 12>>
Gigabit Ethernet Ports as a trunk
<<25, 26>>

• The ports that can be assigned to the same trunk on WGS3-404 are listed below:

Two ports as a trunk
<<1, 2>> <<3, 4>> <<5, 6>> <<7, 8>>
Four ports as a trunk
<<1, 2, 3, 4>> <<5, 6, 7, 8>>

• Ports can only be assigned to one trunk.
• The ports at both ends of a connection must be configured as trunk ports.
• The ports at both ends of a trunk must be configured in an identical manner, including

communication mode, and VLAN assignments.

• None of the ports in a trunk can be configured as a mirror or monitor port.
• All the ports in a trunk have to be treated as a whole when moved from/to, added or deleted from

a VLAN.

• The Spanning Tree Algorithm will treat all the ports in a trunk as a whole.
• Enable the trunk prior to connecting any cable between the switches to avoid creating a loop.