beautypg.com

Planet Technology WGS3-2620 User Manual

Page 178

background image

WGS3 Layer 3 Switch User’s Manual

- 170 -

are attaching to is VLAN-aware), and configure an IP interface for this VLAN if you need to connect it to

other group.

This parameter is for WGS3-2620 only. WGS3-404’s default setting is Rx All and use VLAN Table

Configuration for Tx.

Parameter Default Description

GVRP

Enabled

Enables or disables GVRP for this port. When disabled, any GVRP

packets received on this port will be discarded and no GVRP registrations

will be propagated from other ports.

Note that GVRP must be enabled globally for the switch before this

setting can take effect. (See “4.5.3.1 Configuring Global Bridge Settings”)

GMRP

*4

Enabled

Enables or disables GMRP for this port. When enabled, this port will allow

end stations to register with multicast groups using GMRP. Note that

GMRP must be enabled for the switch before this setting can take effect.

IGMP and IGMP Snooping also provide multicast filtering. (See “6.4.2

IGMP Protocol”)

Ingress

Filtering

*5

Disabled

If enabled, incoming frames for VLANs which do not include this ingress

port in their member set will be discarded at the ingress port.

4: Only displayed on WGS3-2620.

5: This control does not affect VLAN independent BPDU frames, such as GVRP or STP. However, they

do affect VLAN dependent BPDU frames, such as GMRP.