beautypg.com

2 port description, 3 led definition, 3 rear panel of wgs3-2620 and wgs3-404 – Planet Technology WGS3-2620 User Manual

Page 14

background image

WGS3 Layer 3 Switch User’s Manual

- 6 -

2.2.2.2 Port Description

Ports

# of Ports

Description

10/100/1000

4

These RJ-45 ports support network speeds of 10, 100 or 1000 Mbps,

and can operate in full-duplex modes.

Expansion

Ports

4

These ports provide for the installation of one or two expansion

modules that establish a Fast or Gigabit Ethernet connection.

Note: You may install an 1000Base-SX or 1000Base-T expansion

module and use fiber optic or category 5 cabling.

2.2.2.3 LED Definition

The LEDs indicate the status of 10/100/1000 Mbps Ethernet ports, Over Heat, Fan Failure and Power.

The LEDs are explained in the following tables.

LED

Color

Indication

System

Power Green

Lights to indicate switch is receiving power.

Fan Failure

*1

Red Lights to indicate one of the fans is failed and standby fan is

running

Over Heat

*2

Red

Lights to indicate the internal temperature is equal to or higher

than 60 degree C

10/100/1000 Ports

Act

Green

Lights to indicate the Switch is actively receiving or sending the

data over the port.

FDX/COL

Yellow

Lights green to indicate that the port is operating in full-duplex

mode.

Blinks orange periodically to indicate that the connection is

experiencing collisions.

1000

Green

Lights to indicate that the Switch is sending or receiving data at

1000 Mbps.

100

Green

Lights to indicate that the Switch is sending or receiving data at

100 Mbps.

10

Yellow

Lights to indicate that the Switch is sending or receiving data at

10 Mbps.

*1 There are two 4-inch fans and one 2-inch fan in the unit. Normally, one of the 4-inch fans and

2-inch fan is running. Another 4-inch fan is standby and not working. Once one of the two

running fans is failed, the standby fan will be drove to run and the Fan LED will light on.

*2 When the internal temperature is equal to or higher than 60 degree C, the standby fan will be

drove to run and the Temp LED will light on. Once the temperature is equal to or higher than 70

degree C, the buzzer will sound. You can press the buzzer On/Off button to turn off the buzzer.

2.2.3 Rear Panel of WGS3-2620 and WGS3-404

The rear panel of WGS3-2620 and WGS3-404 has a power connector, a Buzzer button and a console

port. The following picture shows their rear panel.