beautypg.com

5 configuring ip settings – Planet Technology WGS3-2620 User Manual

Page 184

background image

WGS3 Layer 3 Switch User’s Manual

- 176 -

5.7.5 Configuring IP Settings

If this switch is WGS3-404 or WGS3-2620 in multilayer mode, the IP Menu will be displayed.

Use this menu to configure the IP subnets for each VLAN on your switch, the unicast and multicast

routing protocols, static ARP entries, static IP routes, and the default IP route.

Parameter

Description

Subnet

Configuration

IP Subnet Configuration – Specifies the IP interface for VLANs configured on this

switch, including the subnet address and routing protocols.

Port Group Configuration – See “5.7.3.2 VLAN Table Configuration”.

Protocol

Configuration

Configures ARP timeout, enables Proxy ARP, sets the preferred servers for

BOOTP/DHCP Relay, as well as enabling/configuring unicast and multicast protocols

globally for this switch.

Static ARP

Configuration

Used to map an IP address to a specific physical MAC address.

Static Route

Used to configure static routes to other IP networks, subnetworks, or hosts.

Default Route

Defines the router to which this switch will forward all traffic for unknown networks.