beautypg.com

Planet Technology WGS3-2620 User Manual

Page 224

background image

WGS3 Layer 3 Switch User’s Manual

- 216 -

VLAN

The VLAN within which the gateway or destination address resides.

Next Hop

The IP address of the router at the next hop.

Type

The IP route type for the destination network. This switch supports the following

types:

Direct - A directly connected subnetwork.

Indirect - A remote IP subnetwork or host address.

Myself - A switch IP address on a specific IP subnetwork.

Bcast - A subnetwork broadcast address.

Mcast - An IP multicast address.

Invalid - A illegal IP address to be filtered.

Protocol

The route was learned in one of the following ways:

Local - Manually configured

Mgmt. - Set via SNMP

ICMP - Obtained via ICMP redirect.

RIP - Learned via RIP protocol.

OSPF – Learned via OSPF protocol.

Other - Learned by some other method.

Route Tag*

The route tag represents the device that originated this routing entry.

Route Aging*

The number of seconds elapsed since this route was last updated or otherwise

determined to be correct. (This entry only applies to RIP.)

Routing Metric*

A relative measure of the path cost from this switch to the destination network. (This

value depends on the specific routing protocol.)

*These three options is only for WGS3-2620.