beautypg.com

3 displaying bridge information, 1 viewing the current spanning tree information – Planet Technology WGS3-2620 User Manual

Page 216

background image

WGS3 Layer 3 Switch User’s Manual

- 208 -

5.8.3 Displaying Bridge Information

The Bridge menu is used to display settings for the Spanning Tree Algorithm. For a more detailed

description of how to use this algorithm, refer to “6.1.3 Spanning Tree Algorithm”.

Menu Description

Spanning Tree Bridge

Information

Displays a full list of STA values used for the bridge.

Spanning Tree Port

Information

Displays a list of STA values used for each port, including status, designated cost,

designated bridge, and designated port.

5.8.3.1 Viewing the Current Spanning Tree Information

The STA Bridge Information screen displays a summary of STA information for the overall bridge. To

make any changes to these parameters, use the Bridge STA Configuration menu as described on 5.7.2

Using the Bridge Menu. The parameters shown in the following figure and table describe the current

Bridge STA settings.

Parameter Description

Priority

Device priority is used in selecting the root device, root port, and designated port. The

device with the highest priority becomes the STA root device. However, if all devices

have the same priority, the device with the lowest MAC address will then become the

root device.

Hello Time

The time interval (in seconds) at which the root device transmits a configuration

message.

Max Age

The maximum time (in seconds) a device can wait without receiving a configuration

message before attempting to reconfigure.