Printronix L5535 - Manual (Page 147)

Reprinting Pages After Fault Condition
147
Fanfold paper: the printer reprints all pages that have not
completely exited the printer at the time of failure. The exact
number of pages that are reprinted is determined by the length of
the page and where within the page the fault occurred.
Cut sheet paper: the printer determines how many pages did not
exit the printer, and reprints all pages that did not exit.
If Reprint on Fault is disabled:
Any pages left in the printer at the time of failure will not be
reprinted. Data is lost (you will need to reprint the lost pages
according to your application software.)
If Reprint on Fault is confirm:
The control panel on the printer returns a message asking whether
or not to reprint. Answer Yes to reprint, answer No if a reprint is not
necessary.
Whether Reprint on Fault is enabled, or disabled, or confirm:
After a paper jam, you may need to reload the paper onto the
tractors.
“Error Messages,” on page 152, designates those errors that
require reprinting to recover from an error condition.
NOTE: Some errors require reprinting, regardless of your printer
configuration.
Procedure For Fault Clearing - Reprint On Fault Disabled
1. A fault occurs.
2. Correct the fault condition.
3. Press CLEAR.
4. The STAND BY LED blinks and the following message appears
while the printer attempts to clear the fault:
• If the fault is not cleared:
Standby ...
Clearing Fault