Epson Stylus Pro 7000 - Manual (Page 56)

2-22
2-22 | Handling Paper
5. Examine the printed pattern to determine which set of lines is the
straightest (shows the smallest gap), and note the corresponding
number.
In the sample pattern, the lines under number 4 are the straightest.
6. Press the + or - button to select the number noted in step 5. Then press
the Enter button.
7. Press the Item button. DRYING TIME=0 MIN appears on the display.
Press the + or - button to select the time in minutes, then press the
Enter button. Start with one minute. If ink still smears, increase the
drying time.
This is how long the printer will pause between pages (or before cutting)
to let the ink dry.
8. Press the Item button. SUCTION=NORM* appears on the display. If
you’re registering very thin paper, press the + or - button to select the
LOW setting. Then press the Enter button.
9. Press the Pause or SelecType button to exit the Paper Configuration
menu.
Selecting Registered Paper Settings
Once you have registered a type of paper or other media, you can select it
whenever you print on that paper.
1. Press the SelecType button until PAPER CONFIG. MENU appears on
the display.
2. Press the Item button. You see PAPER NUMBER=1.
3. Press the + or - button to select the registered number you want to use.
Then press the Enter button.
4. Press the Pause or SelecType button to exit the Paper Configuration
menu.
When you change media, make sure you select the correct setting.
If you are not sure what media setting is in effect, you can print a status
sheet, which shows the current settings. See page 5-4 for instructions.