Epson Stylus Pro 7000 - Manual (Page 42)

2-8
2-8 | Handling Paper
• Choose Roll Auto Cut if you want the paper to be cut automatically
after each page is printed.
• Choose Roll Cutter Off if you don’t want the paper cut
automatically.
If you’re using the Auto Cut setting, you can have a trim line
printed on the right edge of your images or pages. If you’re not
using auto cut, you can have the line printed on the right and
bottom edges of your pages. See page 2-12 for instructions.
You can also select roll paper settings through your print options,
which will override the control panel settings. See page 3-2 or 4-6 in
this manual or the RIP Station 5100 User Guide for more
information.
2. Make sure the Operate light and Pause light are not flashing. Then
push the paper set lever all the way down.
Caution
If you’re using thick roll
paper, choose Roll
Cutter Off. Paper that is
too thick may damage the
cutter.
Caution
To avoid damaging the
printer, never move the
paper set lever while the
Operate or Pause light is
flashing.