Epson Stylus Pro 7000 - Manual (Page 109)

6-17
Maintaining and Transporting the Printer | 6-17
Setting Up the Printer After Transporting It
Setting up the printer after transporting it is almost identical to setting it up
for the first time. Whenever you set up the printer, see the Assembly and
Setup Instructions.
EPSON recommends installing new cartridges after transporting the printer.
Because of the ink charging process, you will not be able to save ink by
reinstalling used cartridges.
Moving the Printer on the Stand
If you’re using the printer stand and you need to move the printer a short
distance, such as within the same building or facility, you can roll the printer
on its casters. Follow these steps:
1. Make sure that the power cord, interface cable, roll paper spindle and
paper are removed, and the roll paper cover and lower cover are closed.
You don’t need to remove the ink cartridges.
2. Release the front casters and retract the stabilizer knobs.
3. Carefully roll the printer to its new location. Relock the casters and
extend the stabilizer knobs after moving.
The first time you start printing after moving the printer, the print head
nozzles may be clogged. You may need to run a cleaning cycle (see page 6-2)
and realign the print head (see page 6-3) to ensure good print quality.
Caution
Do not roll the printer
on angled or uneven
surfaces.