Epson Stylus Pro 7000 - Manual (Page 101)

6-9
Maintaining and Transporting the Printer | 6-9
6. Close the ink compartment cover.
Replacing the Paper Cutter Blade
If you notice that your paper isn’t cut cleanly, the cutter blade may need to
be replaced. If you use the blade to cut heavy stock or non-EPSON media,
you may need to replace it more often. You can also check the status of your
cutter by printing the status check sheet or using the Printer Status menu on
the control panel. See page 5-4 or 5-3 for instructions.
To obtain a new cutter blade (part number C815131), contact your dealer.
To replace the cutter blade, you first need to remove the used blade, as
described in the following section.
Removing the Used Cutter Blade
Make sure the printer is on, then follow these steps to remove the blade:
1. Press the SelecType button repeatedly until CUTTER REPLACE
MENU appears on the display.
2. Press the Item button. CUT. REPLACE=EXEC. appears on the display.
3. Press the Enter button. The paper cutter holder moves to the
replacement position.
Note
If the Ink Out light
remains on, the cartridge
may not be installed
correctly. Remove the
cartridge and then
reinsert it as described
above.
Warning
Be careful not to cut
yourself while replacing the
paper cutter blade.
Caution
To avoid damaging your
printer, never move the
paper cutter holder by
hand.