Planar M46L - Manual (Page 59)

Zoom and Viewport
m40L/m46L Installation & Configuration Guide 49
Zoom and Viewport
Zoom fits the edges of a large picture - one that covers many displays’ screens - from
side-to-side and top to bottom.
Note: Zoom and Viewport adjustments are mainly used for Planar’s cube products with no
mullions. Users with direct-view LCD monitors can skip this section.
To access the Zoom menus, press SIZE / POS twice on the remote to open the ZOOM
TOP & LEFT menu. Press SIZE / POS a third time to open the ZOOM BOTTOM & RIGHT
menu.
You may zoom the sides up to +100 pixels larger in each direction. You may also
zoom the sides up to –100 pixels smaller, but only if that side is not the edge of the
overall picture. An example may help make this point more clearly.
The picture is cropped and there is some extra picture to the right, off the screens. All
the displays can be zoomed out (+) to make the picture larger in each direction.
Unit X cannot be zoomed in (–) at the bottom or the left side, because there is no
more picture to pull onto the screen.
Unit Y cannot be zoomed in at the bottom, but it can be zoomed in from the right (–)
because there is more picture out there. Of course, the center display - Column 2,
Row 2 - can be zoomed in any direction.
This is the original picture from the source.
Unit Y
Unit X