Panasonic 524X07801B - Manual (Page 227)

Section 700 - Operation Chapter 6. DSLT Features
576-13-700 DBS 576 (USA), Revised 6/11/98 227
Operation
To establish an eight-party conference call from the idle status:
To establish an eight-party conference call from your current call:
Hardware Requirements
• N/A
Related Programming
• FF1-0-03: Extension COS (8-Party Conference)
• FF3: Extension COS
Considerations
• A Conference Card (VB-44120) must be installed in the System in order to use Eight-party
Conferencing.
• If the originating party hangs up, the conference call will be disconnected. If any other party
hangs up, the conference call will remain in progress.
Action Result
1. Lift the handset or press the ON/OFF key. Intercom dial tone
2. Enter the Eight-Party Conference code (default = 788).
3. Press the HOLD key.
4. Enter a trunk access code, or dial the number of the exten-
sion you wish to add to the call.
5. If you entered a trunk access code in step 4, dial the number
of the party you wish to add to the call. Otherwise, proceed
to step 6.
6. Press the CONF key when your call is answered. Connected to called party
7. To add additional parties to the call, repeat steps 3-6.
Action Result
1. While on a call, press the HOLD key. Current call on hold
2. Enter the Eight-Party Conference code (default = 788).
3. Enter a trunk access code, or dial the number of the exten-
sion you wish to add to the call.
4. If you entered a trunk access code in step 3, dial the number
of the party you wish to add to the call.
5. Press the CONF key when your call is answered.
6. To add additional parties to the call, press the HOLD key
and repeat steps 3-5.