Panasonic 524X07801B - Manual (Page 125)

Section 700 - Operation Chapter 5. Key Telephone Features
576-13-700 DBS 576 (USA), Revised 6/11/98 125
To retrieve a call placed on System Hold from an extension other than the one that put
it there:
To retrieve a held call on a specific trunk:
Hardware Requirements
• N/A
Related Programming
• FF1-0-01: Floating Hold on HOLD Key
• FF1-0-03: Extension COS (Hold Key Operation)
• FF1-2: Dial Plan
Considerations
• N/A
Floating Hold
Floating Hold is a type of System Hold that allows you to retrieve a held call from any extension that
has an FF key assigned to the same Floating Hold orbit where the call is held. You can also retrieve a
call by dialing the Floating Hold orbit number for the held call.
Floating Hold is useful when the intended recipient of a call must be located via a page. The call can
be placed in a Floating Hold “orbit” and that orbit number announced during the page. The paged
party can then pick up the call by dialing the orbit number or by pressing an FF key assigned to that
orbit number.
Note: To place a call on Floating Hold, you should have at least one FF key assigned to a Floating
Hold orbit number (001-576).
Operation
To place a call on Floating Hold:
Action Result
1. Press the line key that is flashing red. CO XXX displays (where XXX = outside
line number)
Action Result
1. Lift the handset or press the ON/OFF key. Intercom dial tone
2. Enter the Specified Trunk Answer code (default = *0). Enter TRK # displays
3. Enter the trunk number.
Action Result
1. While on a call, press the Floating FF key (system program-
ming required) or press the HOLD key.
• Intercom dial tone
• Hold CO XXX displays (where XXX
= outside line number)