Printronix ThermaLine T5000r - Manual (Page 91)

Error Messages
91
Unscannable code
check media
(continued) 6. Press PAUSE to clear
the message.
7. In the VALIDATOR
menu, press
↓ until
Clear Data displays,
then press
↵
.
Validator not
communicating 1. The Validator Funct. =
Enable in the
VALIDATOR menu, but
when the printer was first
powered up it could not
communicate with it.
2. The validator was
connected to the printer
and then later removed.
1. Check that the validator
signal cable is securely
connected to the
validator unit.
2. Select Validator Funct.
= Disable in the
VALIDATOR menu.
Save this setting in the
Power-Up configuration
in the CONFIG CTRL
menu and reboot the
printer.
Table 6. Message List
Message Explanation Solution