Printronix ThermaLine T5000r - Manual (Page 24)

Chapter 1 Installation and Removal
24
Attach The Grounding Wire And Power/Data Cable
Figure 10. Attaching the Grounding Wire and Power/Data Cable
1. Attach one end of the grounding wire to the validator using the
inside adjustment screw as shown in Figure 10.
2. Attach the other end of the grounding wire to the lower bracket
using the fourth bracket mounting screw as shown in Figure 10.
3. Push any excess grounding wire slack through the grommet.
Cable
Channel
Bracket Tab
Grommet
Upper Bracket
Screw (3)
Bracket Mounting Screw
Inside
Adjustment
Screw
Power/Data Cable
(Long Connector)
Grounding
Wire
Grounding Wire
Slack
A
A
Validator
(Front View)