Print settings, Chapter 2 – Printronix ThermaLine T5000r User Manual

Page 68

Chapter 2

Configuring The Validator

Print Settings

This is an executable menu item that reads and prints the settings
used by the validator.

The response received from the validator after sending the ~DV
(retrieves version), ~HT (retrieves hardware settings), and ~PT8
(retrieves parameter settings) commands are printed. Use the
printout to view all the active settings the validator is using and to
determine if there is any invalid setting which may be causing
problems.

The following is a sample printout:

F/W Version: X334

~HT Response:

[~HS###]SOS= 025

[~HP###]Beam Shift= 000 024

[c]HIGHcal= 088

[c]LOWcal= 004

[~Sh##]= 088

[~Sl##]= 004

[c]SCfact= 044

[c]min cal= 031

[~HB#]baud= 003

[~LL]smt_decode= 343

[~LM##]chars= 003

[~LN##]num_bc= 001

[~LZ##]num_bc_exact= 000

[~LR#]No_Read_Enable=000

[~LF##]I25_Mod10_Chk=000

[~HQ#]output_mode= 001

[~HO#]oper_mode= 001

[~LA##]ansi= 005

[~LS##]min_scn= 003

[~LT#]sync_in= 001

[~LP#]sync_pol= 000

[~LX#]sync_typ= 001

[~LV##]sync_md= 000

[~PO#]port_sel= 005

[PC#]port_clear_md= 000

[Pt##]port_time= 099

[~LD##] %dec= 075

[~PR####]PRST= 000200

[~HL#]ladder_code= 000

[~HJ####]ladd_start= 0200

[~HK####]ladd_end= 4000

[~HC####]ana_len= 1800

[~HG####]ana_lenh= 0950

[~HN####]pana_len= 0950

This manual is related to the following products:

SL5000r