Printronix ThermaLine T5000r - Manual (Page 27)

Continuous, Tear-Off, and Tear-Off Strip
27
Adjust The Scanning Beam
NOTE: Make sure the printer is on and the scanning beam is on. If
the beam is off, press the RESET button for less than 2
seconds to turn on the beam.
Continuous, Tear-Off, and Tear-Off Strip
When the validator is first installed, the scanning beam may need to
be aligned with the two notches on the sides of the tear bar, as
shown in Detail A of Figure 11. When the scanning beam is
properly aligned it will line up with the two notches.
Figure 11. Aligning the Scanning Beam: Continuous, Tear-Off, and Tear-Off Strip
Media Handling Modes Only
A
t5lsrlc2
June 19, 2000
A
Notch in Tear Bar
Scanning Beam