Printronix ThermaLine T5000r - Manual (Page 89)

Error Messages
89
Poor scanning
Check media Data validation failure:
percent decode. The validator
detected gross
inconsistencies within the
height of the bar code. These
types of failures are likely
attributed to large blemishes
within the bar code, caused
by ribbon wrinkle or debris on
media. 1. Check for a wrinkled
ribbon or debris on
media. Roll wrinkled
area onto take-up
spindle.
2. Adjust the printhead
pressure blocks. (Refer
to the
Quick Setup
Guide or User’s
Manual.)
Poor scanning
Inspect head Data validation failure:
hardware defect. The
validator detected
unexpected dark spots in
spaces or light spots in bars.
This usually indicates a poor
ribbon/media combination, a
dirty printhead, or a burned
pixel. 1. Check that paper and
ribbon are clean,
unwrinkled, and
installed correctly.
2. Clean the printhead.
3. If message reappears,
replace the printhead.
Speed Exceeds
Validator Limit Print Speed is set above the
maximum allowed for bar
code printing by the validator
as the Power-Up
configuration with the
validator option installed.
An attempt was made to set
Print Speed above the
maximum allowed in the
QUICK SETUP menu or via
host software.
Maximum speed depends on
Min. Code Height and Min.
Code Gap.
This message only appears
briefly, and the speed is
automatically reduced.
Make sure Min. Code
Height (page 74) and Min.
Code Gap (page 76) are set
correctly.
Table 6. Message List
Message Explanation Solution