Lexmark 302 - Manual (Page 244)

Positioning Forms
When you design the forms layout for your printer, keep the physical
dimensions and forms quality in mind. See Figure C-1 on
page C-10 and Figure C-2 on page C-11 and the following
information to obtain best results when printing.
A Form Width
Maximum: 381 mm (15 in.) for F1, F2, or F3
356 mm (14 in.) for F4
Minimum: 76.2 mm (3 in.) for F1, F2, or F3
127 mm (4 in.) for F4
B Form Length
Maximum: 356 mm (14 in.)
Minimum: 76.2 mm (3 in.) for F1 and F2
Minimum: 177.8 mm (7 in.) for F3
Minimum: 127 mm (5 in.) for F4 (Bin 1)
Minimum: 203 mm (8 in.) for F4 (Bin 2)
Minimum: 279 mm (11 in.) for F4 (Bin 3)
Minimum: 127 mm (5 in.) for F4 (Bin 4)
C First Print Position
For continuous forms:
The minimum distance between the center of the margin holes
| and the start of the first print position used is 1.27 mm (0.05 in.).
The maximum distance between the center of the margin holes
and the start of the first print position used is 48.5 mm (1.91 in.).
For cut forms:
The minimum distance between the left edge of the form and the
| start of the first print position used is 1.27 mm (0.05 in.).
The maximum distance between the left edge of the form and
the start of the first print position used is 48.5 mm (1.91 in.).
C-8 User’s Guide Model 302