Konica Minolta C250P - Manual (Page 102)

Setting up the printer driver 2
C250P 2-39
2
Note
The network settings should be specified according to instructions from
the network administrator.
A password is required in order to enter Administrator mode. Contact the
administrator for the administrator password.
!
Detail
Although the IP address is entered without using the DHCP server in the
procedure described here, it is also possible that the IP address automat-
ically be assigned by the DHCP server. When “IP def. method” is set to
“Auto Input” and “DHCP Setting” is set to “Enable”, the IP address, sub-
net mask and default gateway are automatically assigned by the DHCP
server on the network, so it is not necessary to assign them manually.
However, consider the following when setting “DHCP Setting” to “Ena-
ble”.
Consult with the network administrator to check that a DHCP server ex-
ists. If a DHCP server does not exist, be sure to specify settings for “IP
Address”, “Subnet Mask” and “Default Gateway”.
If the IP address and other settings have been assigned by the DHCP
server, they may automatically be changed. If the IP address and other
settings are changed and a printer on the network has been specified by
its IP address for printing, printing may not be possible since this ma-
chine cannot communicate with the network.
If “DHCP Setting” has been set to “Enable”, it is recommended that a
fixed IP address be assigned to this machine in the DCHP server settings.