Kodak 2400DSV - Manual (Page 117)

7 Troubleshooting
110
7.4 Troubleshooting for malfunction code
7.4.1 L2: Projection Lamp malfunction
7.4.2 C1: Scan Unit Drive Malfunction
7.4.3 C2: Scan Mirror Drive malfunction
Check Item Remedy
Check LA1. →NG Replace LA1.
↓OK
The carrier glass is covered by a dark
colored piece of paper or some other
thing that would prevent light from
shining through the glass. →Yes Remove paper or any other obstruction
from the carrier glass.
→No Replace PWB-A.
Replace PWB-BB.
Check Item Remedy
Does the Scan Table Drive Motor
rotate when the Power Switch is turned
ON? →No Wiring Check
Replace the following parts.
PWB-T
PWB-BB
M2
↓Yes
Is C1 shown when scanning motion? →No OK
↓Yes
Check PC3. →NG Replace PC3.
↓OK
Check PC4. →NG Replace PC4.
→OK Replace PWB-BB.
Check Item Remedy
Is C2 shown even when power is
turned OFF, then ON again? →No OK
↓Yes
Does the Scan Motor rotate when the
Power Switch is turned ON? →Yes Check Wiring.
Replace the following parts.
PWB-T
PWB-BB
M1
↓No
Check PC1. →NG Replace PC1.
↓OK
Check PC2. →NG Replace PC2.
→OK Replace PWB-BB.